Plant facilities managers running 15 to 20 year old equipment have good reason to start pricing Modine unit heaters this year. Aging commercial unit heaters tend to fail in a familiar order: more service calls, longer waits on parts, and then a dead unit over a dock door in January. A planned, phased replacement lets the plant decide when the work happens, and it gives the whole facility newer, more consistent equipment.

Compare Aging Units Against New Modine Unit Heaters

Your oldest warehouse heaters have probably outlived their expected service life already. Each repair on an aging unit buys less runtime, because the unit has fewer good years left. ASHRAE’s equipment life data puts median service life at 13 years for gas or electric unit heaters and 20 years for hot water or steam models. New Modine unit heaters start that clock over, and a gas unit hung in 2008 already runs five years past its median. Pull install dates from the asset register and sort every unit by age.

Price Repeat Repairs Against Modine Unit Heaters

Repeat service calls on old gas unit heaters add up, and the fuel bill adds to the total. An older, less efficient gravity vented unit burns more fuel for every hour of heat it puts out, so it keeps costing the plant between repairs. Modine’s own comparisons put gravity vented units at 65% seasonal efficiency and power vented units at 78%, while the Effinity93 line of Modine unit heaters runs at 93% thermal efficiency. Total the last three years of repair invoices for each unit and set that figure beside a replacement quote.

Move Units Built Before 2008 to the Top

Units built before 2008 make the clearest first phase in any replacement plan. They predate the federal energy standard that every unit heater on the market today has to meet, so they should be replaced first. That standard, 10 CFR 431.246, covers every unit heater manufactured on or after August 8, 2008. Check each rating plate for the build date and mark anything earlier for the first round of replacements.

Keep Every Fuel Type Under One Brand

Plants that buy one brand across the whole floor spend less time and money keeping heaters running. Technicians who service one brand and a short list of models don’t need as many spare parts on the truck, and they’ll find faults faster. Modine builds gas fired models, electric unit heaters, and hot water unit heaters under one name, and its Effinity93 line alone comes in ten sizes from 55,000 to 310,000 Btu/hr input. Group every unit by fuel type and plan each group around the matching Modine line.

Replace Units in Batches Between April and September

Warm months give a plant room to swap heaters without leaving anyone cold. Pulling a heater in April doesn’t cost a plant anything in comfort, but the same job in January leaves a bay without heat until a contractor hangs the replacement. Ordering each phase as one batch keeps the units matched. A long running line also makes later phases easier to match, since Modine has sold the Effinity93 since 2009. Split the fleet into two or three phases and book each one for the warm months.

Buy Modine Unit Heaters Through an Authorized Distributor

A fleet order should go through a seller the manufacturer recognizes, and that matters more on a 20 unit order than on a single replacement. Buying from an authorized distributor means the units come through the distribution network of a company Arthur Modine founded in Racine, Wisconsin, back in 1916. NorthStock is an authorized Modine distributor. If your replacement plan is ready, reach out to them today.

For more information about Explosion Proof Heater and Hydronic Heater Please visit: NorthStock Inc.

Leave a Reply